How it goes together
Everything arrives printed and numbered. No glue, no printer.
-
Wind in the pegs
Use the key to wind each peg into the backplate. The guide shows which peg goes where.
-
Press on the layers
Start at the back and work forward. Every piece is numbered, so you always know what comes next.
-
Replace with: photo of a finished piece on its stand, on a shelf.
Put it up
Hang it on the wall, or stand it on a shelf. Both come in the box.
What’s in the box
- Backplateeverything attaches to it
- Printed piecesnumbered on the back
- Pegssorted by length
- The keywinds the pegs in
- Wall cleat and standhang it or stand it
- Build guideprinted, and online
Hanging it? You’ll need a couple of screws to suit your wall.
The designs
The first three, shown at their real sizes next to a light switch.
Questions
Do I need a 3D printer?
No. Everything arrives printed. You put it together and hang it, or stand it on a shelf.
How long does it take to build?
About an hour. The guide takes you one layer at a time, so you only ever look for the next few pieces.
How big are they?
Between about 18 and 30 cm across. Each design’s page has its exact size.
What are they made of?
Matte PLA plastic. Every colour is its own printed piece, so nothing is painted.
Do I have to put holes in the wall?
No. Every kit comes with a stand, so it can sit on a shelf or a desk. The wall cleat is there if you want it up.
How does it hang?
Screw the cleat to the wall and lower the backplate onto it. It hooks on and sits flush. Screws aren’t included, so you can pick ones that suit your wall.
When can I get one?
The first batch is nearly ready. Leave your email below and we’ll write once, when it ships.
Get one from the first batch
We’ll email you once, when it ships. Nothing else.
You’re on the list. We’ll email you once, when the first batch ships.